Distortion Analyzer

No Comments

  3% full scale Accuracy 0.001% Resolution 10Hz to 600kHz Frequency Response Hi Resolution Color Display Isolated Input IEEE-488, USB Distortion readings to almost 100%.

Current Source

No Comments

  Current 8 mA … 120 A (AC/DC) Frequency 15 Hz … 1 kHz Best accuracy 0.035 % Simulated current and transconductance amplifier Built-in process multimeter Output capability 8 Vpk RS232, IEEE488 (SCPI)

Portable Multifunction Calibrator

No Comments

  Wide voltage range from 0 to 1000 V DC/AC with accuracy 0.007 % Extended current range from 0 to 20 A DC/AC with accuracy 0.02 % in version M143, range from 0 to 2 A AC/DC in version M143i Extended current range to 1000 A using Meatest Option 140-50 Current […]

Voltage-Current Calibrator

No Comments

  AC/DC Output Wide Range – 1 Millivolt to 1100 Volts, 1 Microampere to 5 Amperes High Accuracy Ease of Operation High Stability Direct Reading Percent Deviation of Output Control High Burden and Compliance Ratings Short Circuit and Overburden Protection Continuous Resolution Run-up for Analog Meter Friction Testing Compact Size […]

Transconductance Amplifier

No Comments

  Highly Accurate 7 Volt Compliance 100 Amperes to 100 kHz 200 mA to 100A in six ranges 100% over range capability 40ppm short term stability 0.04% dc and 0.10% ac accuracy Accuracy independent of load Distortion below -60dB Complete Front Panel Calibration IEEE-488.2 Interface standard Stable with inductive loads […]

Multifunction Calibrator

No Comments

  Current Calibrator to 20 A Exceptional Uncertainties Voltage Calibrator to 1000 V Extremely User Friendly Power Calibrator to 2400 W NIST Traceable

Phase Meter Current Shunts

No Comments

Phase Meter

No Comments

  0.020º Accuracy 0.001º Resolution 5Hz to 1MHz Frequency Response Hi Resolution Color Display Isolated Inputs IEEE-488, USB Current / Voltage Phase Measurements

Phase Standard

No Comments

  1 m° Phase Resolution 5m° Phase Accuracy 1 Hz to 200 kHz 50mv to 120V rms Outputs Amplitude Accuracy Typically 0.3% to 100kHz Output Current >15mA Phase Accuracy Maintained for 1000:1 Amplitude Ratios -80dB Typical Distortion

Phase Verification Bridges

No Comments

Widgetized Sidebar

This panel is active and ready for you to add some widgets via the WP Admin